TM 5-4930-244-14
4-13. ENCLOSURE ASSEMBLY - REPLACE.
This Task Covers:
a.
Removal
b.
Installation
Initial Setup:
Tools Required
Tool Kit, General Mechanic's: Automotive (Appendix B, Section Ill, Item 1).
Materials Required
None
Equipment Condition
Engine shut down and cool.
Personnel Required
4
WARNING
·
Lift enclosure properly; it is heavy. Unit could shift causing it to fall and
cause injury.
·
Watch for hand and finger injuries when lowering the enclosure onto the
skid Jacks can get in the way.
CAUTION
·
Be certain that all controls are pushed in. Do not damage lights on control
panel during removal.
·
Be sure that all doors are closed on the enclosure
NOTE
It is easier to remove the enclosure when the skid assembly is not on the trailer.
a.
Removal. (Refer to Figure 4-1.)
(1)
Remove four thumb screws (1) to release fuel cap (2) and neck assembly (3) from enclosure (4).
(2)
Remove four lifting rings (5) and four washers (6) from enclosure (4).
(3)
Position one person at each corner of enclosure (4)
(4)
Locate and grasp lifting handles (7)
(5)
Lift enclosure (4) straight up and over skid assembly (8), making sure neck assembly (3) clears opening in
enclosure.
(6)
Place enclosure (4) onto firm level ground.
4-11
