TM 5-3825-230-14&P
b.
Cleaning/Inspection.
(1)
Inspect motor parts for signs of wear, warping, or corrosion.
(2)
Replace any damage or worn parts.
c.
Assembly.
(1)
Install rear roller bearing (14) and front roller bearing (25) in housing (26) using a press.
(2)
Install thrust bearing (24), thrust washer (23), square cut seal (22), backup shim (21), shaft seal (20),
backup seal (19), backup shim (18), seal carrier (17), snap wire (16), and seal (15).
(3)
Install shaft (12) into rear of housing (26) and install seal (13).
NOTE
Flat end of drive link goes in first.
(4)
Install thrust bearing (10) and drive link (11) in housing (26).
(5)
Refer to matchmarks and install manifold plate (9) and manifold boot (8) over drive link (11) .
(6)
Install two seals (7) on rotor assembly (6).
(7)
Refer to matchmarks and install rotor assembly (6) on end of drive link (11).
(8)
Install four steel balls (5) in holes in balance plate (4) and place flat side of balance plate (4) against rotor
assembly (6).
(9)
Install seal (3) on cover (2).
WARNING
Adhesives, solvents and sealing compounds can burn easily, can give off harmful vapors and are
harmful to skin and clothing. To avoid injury or death, keep away from open fire and use in well-
ventilated area. If adhesive, solvent, or sealing compound gets on skin or clothing, wash
immediately with soap and water.
(10)
Apply thread locking compound to threads of seven screws (1) and install cover (2). Tighten screws to 45
to 55 lb-ft (61 to 74 N•m) using a torque wrench and 9/16 in. socket.
NOTE
Follow-on maintenance: Install hydraulic motor (para 4-102)
END OF TASK
5-101
