TM 5-3825-230-14&P
5-40. HYDRAULIC MOTOR REPAIR (CONT).
(3)
Remove balance plate (4) and four steel balls (5) from balance plate (4).
(4)
Matchmark exposed side of rotor assembly (6) and remove from motor assembly.
(5)
Remove two seals (7) from rotor assembly (6).
(6)
Matchmark exposed side of manifold boot (8) and manifold plate (9).
(7)
Remove manifold boot (8) and manifold plate (9).
(8)
Remove thrust bearing (10) and drive link (11).
(9)
Push shaft (12) out to rear of housing (26) and remove seal (13) from housing (26).
(10)
Remove seal (15).
(11)
Press seal carrier (17) in and remove snap wire (16) using needle nose pliers.
(12)
Remove seal carrier (17), (includes: backup shim (18), backup seal (19), and shaft seal (20)), backup shim
(21), square cut seal (22), thrust washer (23), and thrust bearing (24).
(13)
Drive out front roller bearing (25) and rear roller bearing (14) from housing (26) using a drift and ball peen
hammer.
5-100
