TM 5-3825-230-14&P
5-35. STARTER REPAIR (CONT).
(11)
Perform continuity check of windings for shorted or open condition. Replace if shorted or open.
(12)
Visually inspect windings for evidence of extreme heat or chafing against armature. Replace winding if
damaged.
(13)
Check for binding of clutch on shaft. If shaft is damaged, dress with crocus cloth. If bore of clutch is damaged,
replace clutch or bushing.
(14)
Inspect bushings for cracks or chipping.
c. Assembly.
NOTE
• If brushes were removed from brush
plate, it may be necessary to solder
wires leading from the brush plate.
• Brushes must be in contact around
end of armature as they are installed.
(1)
Install four brushes (36), four springs (35), and
four clips (34) on brush plate (37).
(2)
If removed install bushing (33) in commutator
end shield (32) using a press.
5-88
