TM 5-3825-230-14&P
4-80. CONTROL PANEL REPLACEMENT (CONT).
(4)
Tag and remove four wires (8) from key switch
(9).
(5)
Loosen two screws (10) using a flat tip
screwdriver and tag and remove two wires (11)
from push-button (12).
(6)
Remove three nuts (13) and three star washers
(14) using a 11/32 in. open end wrench.
(7)
Tag and remove five wires (15) from fuel gage
(16).
(8)
Remove three nuts (17) and three star washers
(18) using a 11/32 in. open end wrench.
(9)
Tag and remove three wires (19) from ammeter
scale (20).
(10)
Remove two screws (21) using a flat tip
screwdriver and tag and remove two wires (22)
from spray pump switch (23).
(11)
Remove two nuts (24), four lockwashers (25),
two washers (26), and two screws (27) using a
7/16 in. open end wrench, ratchet, and 7/16 in.
socket. Remove panel (4) from vehicle.
(12)
Tag and remove panel ground wire (28).
(13)
Tag and remove panel light sockets (29) from ammeter scale (20) and fuel gage (16).
b. Installation.
(1)
Install panel ground wire (28), two screws (27), two washers (26), four lockwashers (25), and two nuts (24) using
a 7/16 in. open end wrench, ratchet and 7/16 in. socket.
(2)
Install two wires (22) and two screws (21) on spray pump switch (23) using a flat tip screwdriver.
(3)
Install three wires (19), three star washers (18), and three nuts (17) on ammeter gage (20) using a 11/32 in. open
end wrench.
(4)
Install five wires (15), three star washers (14), and three nuts (13) on fuel gage (16) using a 11/32 in. open end
wrench.
(5)
Install two wires (11) and two screws (10) on push-button (12) using a flat tip screwdriver.
(6)
Install three wires (8) on key switch (9).
4-128
