TM 5-3825-230-14&P
(2)
Remove two connecting bolts (9), four
copper washers (10), two barbed fittings
(11), and bleed line (12) from injector
assemblies (13) using a 12 mm open end
wrench.
(3)
Remove screw (14) and wire clamp (15)
using a cross tip screwdriver.
b.
Installation.
(1)
Install copper washer (5), barbed fitting
(6), washer (4), deaeration plug (3),
copper washer (2), and connecting bolt
(1). Tighten with 17 mm open end wrench
and flat tip screwdriver.
(2)
Install clamp (8) on bleed line (7).
(3)
Install bleed line (7) on barbed fitting (6),
and crimp clamp (8) using crimpers.
(4)
Install two copper washers (10), two
barbed fittings (11), two copper washers
(10), bleed line (12), and two connecting
bolts (9) on injector assemblies (13).
Tighten using a 12 mm open end wrench.
(5)
Install screw (14) and wire clamp (15)
using a cross tip screwdriver.
NOTE
Follow-on maintenance:
Fuel valve opened (para 3-15)
Bleed fuel system (para 4-36)
Top access panel installed (para 4-98)
Left and right side access covers
closed (para 3-5)
END OF TASK
4-65
