TM 5-3805-296-23-5
0361
INSTALLATION
000361
WARNING
Wheels must remain chocked during entire procedure. Failure to follow this warning may
result in injury or death to personnel.
WARNING
Use caution when using adhesives and sealants. Prolonged inhalation of vapors can
cause lung irritation. Contact with skin can cause dermatitis. Wear gloves and safety
goggles and use product in a well-ventilated area away from open flame. If ingested, keep
individual calm and seek medical attention. DO NOT induce vomiting. If contact with skin
or eyes is made, flush thoroughly with water. Dispose of cleanup rags IAW local policy and
ordinances. Failure to follow this warning may result in injury to personnel.
NOTE
Remove plugs and caps from air tubes and fittings.
1. Apply sealing compound to threads of stop lamp switch (Figure 2, Item 1) and install stop lamp switch
on fitting (Figure 2, Item 2) on brake air control valve (Figure 2, Item 3).
NOTE
Install wiring harness connector as tagged during removal.
2. Connect main cab wiring harness connector (Figure 2, Item 5) on stop lamp switch connector
(Figure 2, Item 4).
Figure 2. Stop Lamp Switch.
0361