TM 5-3805-296-23-4
0287
INSTALLATION CONTINUED
3. Turn transmission engine speed sensor (Figure 3, Item 4) in hole on flywheel housing (Figure 3, Item 5) by
hand until end of sensor contacts flywheel gear tooth.
CAUTION
Do not allow transmission engine speed sensor to turn while tightening locknut. Failure to
follow this caution may result in damage to equipment.
NOTE
Install wiring harness as noted during removal.
Install wiring harness as tagged and marked during removal.
Install new tiedown strap as noted during removal.
4. Turn out transmission engine speed sensor (Figure 3, Item 4) 1/2 turn and tighten jam nut (Figure 3, Item 6).
5. Connect engine interface harness connector (Figure 3, Item 1) to transmission engine speed sensor connector
(Figure 3, Item 7).
6. Install new tiedown strap (Figure 3, Item 3) on ladder clip (Figure 3, Item 2).
Figure 3. Transmission Engine Speed Sensor.
0287
END OF TASK