TM 5-3805-296-23-4
0287
REMOVAL CONTINUED
4. Remove flat washer (Figure 2, Item 2) from transmission engine speed sensor (Figure 2, Item 1). Discard flat
washer .
Figure 2. Transmission Engine Speed Sensor.
0287
END OF TASK
CLEANING AND INSPECTION
000287
1. Clean and inspect all components IAW Mechanical General Maintenance Instructions (WP 0539).
2. Clean and inspect all components IAW Electrical General Maintenance Instructions (WP 0540).
END OF TASK
INSTALLATION
000287
WARNING
Use caution when using adhesives and sealants. Prolonged inhalation of vapors can
cause lung irritation. Contact with skin can cause dermatitis. Wear gloves and safety
goggles and use product in a well-ventilated area away from open flame. If ingested, keep
individual calm and seek medical attention. DO NOT induce vomiting. If contact with skin
or eyes is made, flush thoroughly with water. Dispose of cleanup rags IAW local policy and
ordinances. Failure to follow this warning may result in injury to personnel.
1. Install new flat washer (Figure 2, Item 2) on transmission engine speed sensor (Figure 2, Item 1).
2. Apply sealing compound to transmission engine speed sensor (Figure 2, Item 1).
