TM 5-3805-296-23-2
0150
Table 1. Front and Rear Turn Signals Do Not Operate Continued.
0150
MALFUNCTION
TEST OR INSPECTION
CORRECTIVE ACTION
Front and Rear Turn Signals
3. Disconnect terminal CG-T3
Do Not Operate Continued
(Figure 2, Item 2) from flasher
(Figure 2, Item 1).
4. Using digital multimeter
Resistance 5.0 Ohms or Less
(WP 0540), measure resistance
Replace flasher (WP 0500).
between terminal CG-T3
Proceed to Test Step 9.
(Figure 2, Item 2) and terminal 537
Resistance Greater Than 5.0 Ohms
(Figure 1, Item 4).
Proceed to Test Step 6.
Test Step 6. Test Turn Signal Wiring
Harness for High Resistance or
Open.
1. Remove upper plenum from ROPS
(WP 0504).
2. Disconnect connector P-C2
(WP 0012, Figure 265)
from connector N-C1
(WP 0012, Figure 264).
3. Using digital multimeter
Resistance 5.0 Ohms or Less
(WP 0540), measure resistance
Proceed to Test Step 7.
between connector N-C1
Resistance Greater Than 5.0 Ohms
terminal 1 (WP 0012, Figure 264)
Replace turn signal wiring harness
and terminal 537
(WP 0525).
(Figure 3, Item 4).
Proceed to Test Step 9.
Figure 3. Turn Signal Switch and Wiring Harness.
0150