TM 5-3805-296-23-2
0117
Table 1. Steering System Does Not Operate Properly.
0117
MALFUNCTION
TEST OR INSPECTION
CORRECTIVE ACTION
Steering System Does Not
WARNING
Operate Properly
DO NOT disconnect or remove any hydraulic system hoses, tubes, or
fittings unless engine is shut down and hydraulic system pressure has
been relieved. Tighten all connections before applying pressure.
Escaping hydraulic fluid under pressure can penetrate skin.
At operating temperature, hydraulic oil is hot. Allow hydraulic oil to cool
before removing any hydraulic fitting.
Wear protective eye covering and gloves when performing hydraulic
system testing.
Lubricating/hydraulic oils used in performance of maintenance can be
very slippery. Immediately wipe up any spills.
Failure to follow these warnings may result in injury or death to
personnel.
NOTE
Incorrect oil viscosity can be a factor in many different hydraulic system
symptoms.
Test Step 1. Check for Active Codes.
1. Turn battery disconnect switch and
ignition switch to ON position
(TM 5-3805-296-10).
2. At MSD, check for active
Diagnostic Code(s) Active
diagnostic code(s) (WP 0008).
Diagnose and repair active diagnostic
code(s) (WP 0005).
Proceed to Test Step 13.
No Diagnostic Code(s) Active
Proceed to step 3.
3. At MSD, check for active event
Event Code(s) Active Diagnose and
code(s) (WP 0008).
repair active event code(s) (WP 0005).
Proceed to Test Step 13.
No Event Code(s) Active Proceed to
Test Step 2.
Test Step 2. Inspect Hydraulic
Components.
Perform Implement, Cushion Hitch,
Cause of Malfunction Identified and
and Steering Hydraulic System
Repaired During Inspection
Inspection (WP 0171).
Proceed to Test Step 13.
Cause of Malfunction Not Identified
During Inspection, Malfunction
Active Proceed to Test Step 3.
