TM 5-3805-296-23-2
0114
Table 1. Service or Parking Brakes Do Not Release Correctly Continued.
0114
MALFUNCTION
TEST OR INSPECTION
CORRECTIVE ACTION
8. Monitor and record air pressure on
Service or Parking Brakes
Air Pressure Within Specification
gauge (Figure 1, Item 3). Air
Do Not Release Correctly -
Proceed to Test Step 29.
Continued
pressure should be 125 5 psi
Air Pressure Not Within
(862 34 kPa).
Specification
9. Turn ignition switch and battery
Replace air compressor governor
disconnect switch to OFF position
(WP 0261).
(TM 5-3805-296-10).
Proceed to Test Step 28.
10. Close valve (Figure 2, Item 1).
11. Disconnect quick disconnect hose
(Figure 1, Item 5) from quick
disconnect coupling half
(Figure 1, Item 1).
12. Remove quick disconnect coupling
half (Figure 1, Item 1) from
air drain connection
(Figure 1, Item 2).
13. Perform corrective action.
Test Step 6. Inspect Parking Brake
Indicator Operation.
1. Turn battery disconnect switch to
ON position and start engine. Idle
engine for 20 minutes or until air
pressure gauge reaches normal
operating pressure
(TM 5-3805-296-10).
2. Set park brake switch to engage
(brake on) position
(TM 5-3805-296-10).
Indicator Does Not Flash Proceed to
3. Set park brake switch to
Test Step 7.
disengage (brake off) position and
Indicator Flashes Proceed to Test
observe parking brake indicator
(TM 5-3805-296-10).
Step 9.
0114-7