TM 5-3805-296-23-2
0097
Table 1. 0271 Action Alarm Diagnostic Codes Continued.
097
CID FMI
TEST OR INSPECTION
CORRECTIVE ACTION
Test Step 5. Test Fuse Panel Wiring
0271-05 Action Alarm
Harness for High Resistance or
Current Below Normal
Open.
Continued
1. Turn ignition switch and battery
disconnect switch to OFF position
(TM 5-3805-296-10).
2. Disconnect connector CG-C1
(WP 0012, Figure 283) from
connector W-C8
(WP 0012, Figure 282).
Resistance 5.0 Ohms or Less
(WP 0540), measure resistance
Proceed to Test Step 6.
between connector CG-C6
terminal 1 (WP 0012, Figure 309)
Replace fuse panel wiring harness
and connector CG-C1 terminal 12
(WP 0515).
(WP 0012, Figure 283).
Proceed to Test Step 8.
Test Step 6. Test Main Cab Wiring
Harness for High Resistance or
Open.
1. Remove upper and lower plenum
from ROPS (WP 0504).
2. Disconnect connector P-C1
(WP 0012, Figure 253) from
connector W-C7
(WP 0012, Figure 252).
Resistance 5.0 Ohms or Less
(WP 0540), measure resistance
Proceed to Test Step 7.
between connector W-C8
terminal 12 (WP 0012, Figure 282)
Replace main cab wiring harness
and connector W-C7 terminal 52
(WP 0505).
(WP 0012, Figure 252).
Proceed to Test Step 8.
0097-8