TM 5-3805-296-23-2
0083
Table 1. 1295 Apron Float Indicator Diagnostic Codes Continued.
083
CID FMI
TEST OR INSPECTION
CORRECTIVE ACTION
4. Turn battery disconnect switch and
1295-05 Apron Float Lamp
ignition switch to ON position
Current Below Normal
(TM 5-3805-296-10).
Continued
5. At MSD, check for active
1295-5 Apron Float Lamp Current
Below Normal Becomes Inactive
diagnostic code 1295-5 Apron
Float Lamp Current Below Normal
Replace apron float LED (WP 0506).
(WP 0008).
Proceed to Test Step 4.
1295-5 Apron Float Lamp Current
Below Normal Remains Active
Proceed to Test Step 2.
Test Step 2. Test Dash Wiring
Harness for High Resistance or
Open.
1. Turn ignition switch and battery
disconnect switch to OFF position
(TM 5-3805-296-10).
2. Remove throttle lock LED from
connector P-C22 and install LED
on connector P-C26. Connect
connector P-C26 on instrument
panel (WP 0506) (Figure 2).
3. Remove upper and lower plenum
from ROPS (WP 0504).
4. Disconnect connector P-C1
(WP 0012, Figure 253) from
connector W-C7 (WP 0012,
Figure 252).
5. Connect jumper wire between
terminal 29 and terminal 27 of
connector P-C1 (WP 0012,
Figure 253).
6. Using digital multimeter
Resistance 5.0 Ohms or Less
(WP 0540), measure resistance
Proceed to Test Step 3.
between connector terminals of
Resistance Greater Than 5.0 Ohms
connector P-C22 (WP 0012,
Replace dash wiring harness
Figure 322).
(WP 0510).
Proceed to Test Step 4.
Test Step 3. Test Main Cab Wiring
Harness for High Resistance or
Open.
1. Remove jumper wire from
terminal 29 and terminal 27 of
connector P-C1 (WP 0012,
Figure 253).
2. Disconnect connector W-C13
(WP 0012, Figure 89) from
transmission/chassis ECM.
0083-7
