TM 5-3805-296-23-2
0079
Table 1. 1289 Cushion Hitch Solenoid Valve Diagnostic Codes Continued.
079
CID FMI
TEST OR INSPECTION
CORRECTIVE ACTION
3. Disconnect connector A-C6
1289-05 Cushion Hitch
(WP 0012, Figure 134)
Solenoid Current Below
from connector C-C1
Normal Continued
(WP 0012, Figure 133).
4. Using digital multimeter
Resistance 5.0 Ohms or Less
(WP 0540), measure resistance
Proceed to Test Step 3.
between connector C-C1
Resistance Greater Than 5.0 Ohms
terminal 1 and terminal 2
Replace cushion hitch wiring harness
(WP 0012, Figure 133).
(WP 0400).
Proceed to Test Step 7.
Test Step 3. Test Transmission
Wiring Harness for High Resistance
or Open.
1. Remove jumper wire from terminal
1 and terminal 2 of connector C-C2
(WP 0012, Figure 127).
2. Connect jumper wire between
terminal 1 and terminal 2
of connector A-C6
(WP 0012, Figure 134).
3. Disconnect connector A-C1
(WP 0012, Figure 106)
from connector J-C3
(WP 0012, Figure 101).
4. Using digital multimeter
Resistance 5.0 Ohms or Less
(WP 0540), measure resistance
Proceed to Test Step 4.
between connector A-C1
Resistance Greater Than 5.0 Ohms
terminal 10 and terminal 35
Replace transmission wiring harness
(WP 0012, Figure 106).
(WP 0266).
Proceed to Test Step 7.
Test Step 4. Test Chassis Wiring
Harness for High Resistance or
Open.
1. Remove jumper wire from terminal
terminal 1 and terminal 2
of connector A-C6
(WP 0012, Figure 134).
2. Connect jumper wire between
terminal 10 and terminal 35
of connector J-C3
(WP 0012, Figure 101).
3. Disconnect connector J-C8
(WP 0012, Figure 100)
from connector W-C1
(WP 0012, Figure 99).
0079-6