TM 5-3805-296-23-2
0066
Table 1. 0707 Transmission Upshift Solenoid Valve Diagnostic Codes Continued.
066
CID FMI
TEST OR INSPECTION
CORRECTIVE ACTION
3. Connect jumper wire between
0707-05 Transmission Gear
terminal 1 and terminal 2
Actuator Up Solenoid
of connector A-C7
Current Below Normal
(WP 0012, Figure 114).
Continued
4. Turn battery disconnect switch and
ignition switch to ON position
(TM 5-3805-296-10).
5. At MSD, check for active
707-6 Transmission Gear Actuator
diagnostic code 707-5
Up Solenoid Current Above Normal
Transmission Gear Actuator Up
Becomes Active Replace upshift
Solenoid Current Below Normal
solenoid (WP 0274).
(WP 0008).
Proceed to Test Step 5.
707-5 Transmission Gear Actuator
Up Solenoid Current Below Normal
Remains Active Proceed to Test
Step 2.
Test Step 2. Test Transmission
Wiring Harness for High Resistance
or Open.
1. Turn ignition switch and battery
disconnect switch to OFF position
(TM 5-3805-296-10).
2. Do not remove jumper wire from
terminal 1 and terminal 2
of connector A-C7
(WP 0012, Figure 114).
3. Disconnect connector A-C1
(WP 0012, Figure 106)
from connector J-C3
(WP 0012, Figure 101).
4. Using digital multimeter
Resistance 5.0 Ohms or Less
(WP 0540), measure resistance
Proceed to Test Step 3.
between connector AC-C1
Resistance Greater Than 5.0 Ohms
terminal 4 and terminal 16
Replace transmission wiring harness
(WP 0012, Figure 106).
(WP 0266).
Proceed to Test Step 5.
Test Step 3. Test Chassis Wiring
Harness for High Resistance or
Open.
1. Remove jumper wire from
terminal 1 and terminal 2
of connector A-C7
(WP 0012, Figure 114).
2. Connect jumper wire between
terminal 4 and terminal 16
of connector J-C3
(WP 0012, Figure 101).
0066-5