TM 5-3805-296-23-1
0053
Table 1. 0041 Eight-Volt Sensor Supply Diagnostic Codes Continued.
053
CID FMI
TEST OR INSPECTION
CORRECTIVE ACTION
4. Using digital multimeter
0041-04 8 Volt DC Supply
Continuity Replace cushion hitch
(WP 0540), test for continuity
Voltage Below Normal
wiring harness (WP 0400).
between connector C-C1
Continued
Proceed to Test Step 6.
terminal 5 (WP 0012, Figure 133)
No Continuity Proceed to Test
and ground.
Step 3.
Test Step 3. Test for Shorted
Transmission Wiring Harness.
1. Disconnect connector A-C1
(WP 0012, Figure 106) f
rom connector J-C3
(WP 0012, Figure 101).
2. Using digital multimeter
Continuity Replace transmission
(WP 0540), test for continuity
wiring harness (WP 0266).
between connector A-C6
Proceed to Test Step 6.
terminal 5 (WP 0012, Figure 134)
No Continuity Proceed to step 3.
and all other terminals
in connector A-C6
(WP 0012, Figure 134).
3. Using digital multimeter
Continuity Replace transmission
(WP 0540), test for continuity
wiring harness (WP 0266).
between connector A-C1
Proceed to Test Step 6.
terminal 1 (WP 0012, Figure 106)
No Continuity Proceed to step 4.
and all other terminals
in connector A-C1
(WP 0012, Figure 106).
4. Using digital multimeter
Continuity Replace transmission
(WP 0540), test for continuity
wiring harness (WP 0266).
between connector A-C1
Proceed to Test Step 6.
terminal 1 (WP 0012, Figure 106)
No Continuity Proceed to Test
and ground.
Step 4.
Test Step 4. Test for Shorted Chassis
Wiring Harness.
1. Disconnect connector J-C8
(WP 0012, Figure 100)
from connector W-C1
(WP 0012, Figure 99).
2. Using digital multimeter
Continuity Replace chassis wiring
(WP 0540), test for continuity
harness (WP 0305).
between connector J-C3 terminal 1
Proceed to Test Step 6.
(WP 0012, Figure 101) and all
No Continuity Proceed to step 3.
other terminals in connector J-C3
(WP 0012, Figure 101).
0053-6