TM 5-3805-296-23-1
0013
Table 1. 0001 Fuel Injector Diagnostic Codes - Continued.
013
CID FMI
TEST OR INSPECTION
CORRECTIVE ACTION
5. Using digital multimeter
0001-06 Cylinder #1 Injector
Continuity Replace engine injector
(WP 0540), test for continuity
Current Above Normal
wiring harness (WP 0183).
between connector CN-C1
Continued
Proceed to Test Step 4.
terminal 1 (WP 0012, Figure 13)
No Continuity Proceed to step 5.
and all other terminals
in connector CN-C1
(WP 0012, Figure 13).
6. Using digital multimeter
Continuity Replace engine injector
(WP 0540), test for continuity
wiring harness (WP 0183).
between connector CN-C1
Proceed to Test Step 4.
terminal 1 (WP 0012, Figure 13)
No Continuity Replace fuel injector
and ground.
#1 (WP 0232).
Proceed to Test Step 4.
Test Step 3. Test for Shorted Basic
Engine Wiring Harness.
1. Turn ignition switch and battery
disconnect switch to OFF position
(TM 5-3805-296-10).
2. Lower left frame access plate
(WP 0376).
3. Remove four bolts
(Figure 9, Item 1), washers
(Figure 9, Item 2), bushings
(Figure 9, Item 3), and splash
shield (Figure 9, Item 4) from
machine.
Figure 9. Splash Shield and Retaining Hardware.
0013