TM 5-3805-296-23-1
0013
Table 1. 0001 Fuel Injector Diagnostic Codes - Continued.
013
CID FMI
TEST OR INSPECTION
CORRECTIVE ACTION
4. Disconnect connector CM-C1
0001-06 Cylinder #1 Injector
(WP 0012, Figure 30) from engine
Current Above Normal
ECM.
Continued
5. Using digital multimeter
Continuity Replace basic engine
(WP 0540), measure resistance
wiring harness (WP 0251).
between connector CM-C1
Proceed to Test Step 4.
terminal 116 (WP 0012, Figure 30)
No Continuity Proceed to step 6.
and all other terminals
in connector CM-C1
(WP 0012, Figure 30).
6. Using digital multimeter
Continuity Replace basic engine
(WP 0540), measure resistance
wiring harness (WP 0251).
between connector CM-C1
Proceed to Test Step 4.
terminal 116 (WP 0012, Figure 30)
No Continuity Replace engine ECM
and ground.
(WP 0252).
Proceed to Test Step 4.
Test Step 4. Verify Malfunction is
Resolved.
1. Ensure all harness connectors are
connected.
2. Ensure valve cover is installed on
engine (WP 0182).
3. Turn battery disconnect switch to
ON position and start engine or
attempt to start engine
(TM 5-3805-296-10).
4. At MSD, check for active
1-6 Cylinder #1 Injector Current
Above Normal Becomes Inactive
diagnostic codes (WP 0008).
Proceed to step 5.
1-6 Cylinder #1 Injector Current
Above Normal Remains Active
Repeat troubleshooting from the
beginning.
5. Turn ignition switch and battery
disconnect switch to OFF position
(TM 5-3805-296-10).
6. If removed, install splash shield
(Figure 10, Item 4), four bushings
(Figure 10, Item 3), washers
(Figure 10, Item 2), and bolts
(Figure 10, Item 1) on machine.
0013-15