TM
3-4240-309-20&P
ACTION
ITEM
LOCATION
Insert screw (14) in washer (16), loop of nylon
1.
Inlet transition
Housing Unit
cable (15), and hole in inlet transition (5).
Install washer (13) and nut (12).
2.
Place protective cap (11) on inlet transition (5).
3.
Tighten adjusting screw (17) on hose clamp
(10).
Install inlet transition (5) onto dust collector
4.
(9).
NOTE
Be sure dust collector outlet ( 18) is inserted
into exhaust sleeve (7).
Tighten band clamps (6) on exhaust sleeve (7).
5.
Tighten band clamp (8) on inlet transition (5).
6.
7.
Compress airduct hose (3) until it can be
inserted between inlet collar (4) and inlet
transition (5).
Slip airduct hose (3) over inlet collar (4) and
8.
inlet transition (5), and tighten hose clamps (2).
9 . Set POWER switch (1) on compartment control
module to ON.
2-115
