TM 5-3805-296-23-5
0292
INSTALLATION-CONTINUED
WARNING
Use extreme caution when handling heavy parts. Provide adequate support and use
assistance during procedure. Ensure any lifting device used is in good condition and of
suitable load capacity. Keep clear of heavy parts supported only by lifting device. Failure
to follow this warning may result in injury or death to personnel.
NOTE
Gear housing weighs 332 lb (151 kg).
27. Using lifting device, install gear housing (Figure 27, Item 9) and lock (Figure 27, Item 6) on tire and wheel
assembly (Figure 27, Item 1).
28. Back off but do not remove forcing bolt (Figure 27, Item 3), to allow gear housing (Figure 27, Item 9) to fully
seat on tire and wheel assembly (Figure 27, Item 1)
29. Install 18 washers (Figure 27, Item 7) and bolts (Figure 27, Item 8) on gear housing (Figure 27, Item 9).
Tighten bolts to 320 lb ft (434 Nm).
30. Remove lifting device and chain from lifting link (Figure 27, Item 5).
31. Remove two alignment pins (Figure 27, Item 2) from tire and wheel assembly (Figure 27, Item 1).
32. Remove forcing bolt (Figure 27, Item 3), washer (Figure 27, Item 4), and lifting link (Figure 27, Item 5) from
gear housing (Figure 27, Item 9).
Figure 27. Gear Housing Installation.
0292