f.
g.
h.
i.
j.
k.
l.
m.
n.
o.
TM 9-6230-210-13&P
NOTE
Measure the brake discs for wear. If they are worn to less than 1/16-inch (0.5188 cm)
thick, replace both discs.
Unscrew and remove brake nut assembly (12), brake discs (13), ratchet gear (14), pinion shaft assembly (15),
and bushings (16 and 17).
Remove locknut (18), ratchet bolt (1 9), pawl (20), spacer (21), and spring (22) from frame (23).
NOTE
If repair cannot be accomplished with parts contained in the parts kits, replace the
winch assembly.
Replace defective parts.
Install bushing (17), pinion shaft assembly (15), brake disc (13), ratchet gear (14), other half of brake disc (13),
brake nut assembly (12), and bushing (16) in frame (23).
Install retaining ring (11 ) on pinion shaft assembly (15).
Install pawl (20), spacer (21), and spring (22) onto ratchet bolt (19). Then install assembled parts to frame with
nut (18) and tighten the nut.
Install drum assembly (10), frame spacer (9), special capscrew (8), and locknut (7) and tighten.
Install spacer (6), capscrew (5), locknut (4) and tighten.
Install handle (3), flatwasher (2), capscrew (1) and tighten.
Service winch (see above).
4-43
