WARNING
CAUTION
CAUTION
TM 9-6230-210-13&P
ad. Install extension lockbar (16) on base section with bolt (15).
ae. Slide tower sections (20, 19, and 18) into base section (17) and secure extension Iockbar (16).
Tower weighs approximately 250-lbs. (113.4 kg). Use suitable lifting device or serious
personaol injury could result. Four personnel will be required to lift tower assembly onto
trailer if suitable lifting device is not available.
af. Using suitable lifting device, lift tower assembly (14) off cribbing and lower into position on trailer.
Wrap end of cable with tape to seal any sharp edges.
ag. Thread cable (10) around pulley mounted on trailer frame.
ah. Thread three wraps of cable (10) from beneath the pinion shaft.
ai. Thread cable through round hole until it extends 1-inch (2.54 cm) past the two square holes.
Be sure bolt heads are on the inside of the drum.
aj. Secure cable (10) to outside of drum (11), using two bolts (8), one keeper (9), two washers (7), and nuts (6).
ak. Install cradle cleat (5) and install spring dip (4) on cradle cleat.
al. Install power cable (1) into dips (2) on side of tower (3).
am. Install lightbar (para 2.7).
an. Install floodlights (para 2.7).
ao. Inspect cable for proper alignment in tower and perform operational check.
4-34
