2.17 in.
(35mm)
(MIN.)
SIDE VIEW
2.17 IN. (55MM)
(APPROX)
FLAT STOCK
TOP VIEW
1.26 in.
(32 mm)
DIA. CIRCLE
120
120
120
TM 9-4940-568-34
C-8
C-9. BEARING REMOVAL TOOL.
Piece of flat metal stock about .20 in. (5 mm) thick, and 2.17 in. (55 mm) square or round. Three .22 in. (6 mm) bolts
of equal length to extend at least 1.38 in. (35 mm) below the flat stock when installed through it. To use nuts instead of
tapped holes, use longer bolts to compensate for nut thickness.
a.
Locate three holes equally around a 1.26 in. (32 mm) circle on flat stock. Drill and tap holes as needed to match
bolt threads.
b.
Install bolts in flat stock and tighten. Ends of installed bolts should pass through access holes in end of drive
shaft without binding.