5
5
4
CRANKSHAFT
8
6
7
6
7
TM 9-4940-568-34
5-75
b.
Cleaning/Inspection.
(1)
Clean remaining front cover gasket (6) from
gear cover (5) and gear housing (7) gasket
surfaces.
(2)
Inspect the front gear cover (5) for cracks or
damage.
(3)
Clean and dry crankshaft sealing lip surface.
c.
Installation.
The crankshaft sealing lip surface
must be clean, dry and oil free
before installing the gear cover.
Failure to properly clean the
sealing lip surface will result in
an oil leak.
(1)
Install crankshaft seal (8) in the front gear
cover (5), (Para 5-9).
Adhesives, solvents, and sealing
compounds can burn easily, can
give off harmful vapors, and are
harmful to skin and clothing. To
avoid injury or death, keep away
from open fire and use in
well-ventilated area. If adhesive,
solvent, or sealing compound
gets on skin or clothing, wash
immediately with soap and water.
(2)
Apply a thin bead of RTV to the cover side
of the front cover gasket (6) only and
position on front gear cover (5).
NOTE
Ensure crankshaft seal is
positioned on crankshaft when
front gear cover is installed.
(3)
Install the front cover gasket (6) and front
gear cover (5) on gear housing (7).
(4)
Install 20 screws (4) on front gear cover (5).
Tighten screws to 18 lb-ft (24 N.m).
