TM 9-4940-568-34
5-67
Adhesives, solvents, and sealing compounds can burn easily, can give off harmful
vapors, and are harmful to skin and clothing. To avoid injury or death, keep away from
open fire and use in well-ventilated area. If adhesive, solvent, or sealing compound
gets on skin or clothing, wash immediately with soap and water.
(2)
Clean push rod cover with dry cleaning solvent.
(3)
Dry push rod cover with compressed air and inspect for cracks or dents.
c.
Installation.
NOTE
Push rod cover gasket has an adhesive back. Pull off protective cover on gasket to
expose adhesive surface.
(1)
Install push rod cover gasket (6) with adhesive side down on push rod cover (3).
Adhesives, solvents, and sealing
compounds can burn easily, can
give off harmful vapors, and are
harmful to skin and clothing. To
avoid injury or death, keep away
from open fire and use in
well-ventilated area. If adhesive,
solvent, or sealing compound gets
on skin or clothing, wash
immediately with soap and water.
(2)
Apply thin coat of sealing compound to top
of gasket and engine block (7).
(3)
Install push rod cover (3), two preformed
packings (5), and screws (4) on engine block
(7). Tighten two screws to 18 lb-ft (24 N.m).
(4)
Install hose (2) and spring hose clamp (1) on
push rod cover (3).
d.
Follow-On Maintenance:
Install fuel pump, (TM 9-4940-568-20).
Install fuel injection pump, (Para 5-17).
Install fuel filter, (TM 9-4940-568-20).
Install rear panel, (TM 9-4940-568-10).
Connect batteries, (TM 9-4940-568-10).
Start generator set and operate the engine at idle for 5 to 10 minutes and check for leaks,
(TM 9-4940-568-10).
END OF TASK
4
5
2
6
1
7
3
