TM 9-4940-568-343-14 3-5. CRANE LOAD TEST (CONT).TEST WEIGHT9,890 to 9,910 LBS(4,486 to 4,495 KG)2(6)Lower hook block (2) and attach hook block to test weight (9,890 to 9,910 lbs. [4,486 to 4,495 kg]).NOTEOnly use HOIST control lever in Steps (7) through (9). Do not use TELESCOPE orMAST control levers or test will be invalid.If crane will not lift test weight in Step (7), crane has failed load test. Refer totroubleshooting task.(7)Lift test weight three to four ft. (0.92 to 1.2 m) up using hoist.(8)Lower test weight to ground using hoist.(9)Disconnect hook block (2) from test weight.(10)Attach hook block (2) to test weight (10,280 to 10,300 lbs. [4,662 to 4,672 kg]).NOTEOnly use HOIST control lever in Steps (11) and (12). Do not use TELESCOPE or MASTcontrol levers or test will be invalid.Using HOIST control lever, crane should lift test weight a maximum of 1 in. (2.5 cm)before Overload Sensing System (OSS) disables hoist. If hoist lifts test load higher than 1in. (2.5 cm), OSS is not functioning correctly and crane has failed load test. PerformTroubleshooting OSS task, TM 9-4940-568-20.OSS disables hoist only in the direction of raising. OSS does not effect hoist lowering.(11)Attempt to lift test weight using hoist.(12)Lower test weight to ground using hoist.(13)Disconnect hoist hook block (2) from test weight.
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business