TM 9-4940-568-20
4-19
c.
Cleaning/Inspection.
Drycleaning Solvent (P-D-680) is TOXIC and flammable. Wear protective goggles, face
shield, and gloves; use only in a well-ventilated area; avoid contact with skin, eyes, and
clothes, and do not breathe vapors. Keep away from heat or flame. Never smoke when
using solvent. The flashpoint for Type II Drycleaning Solvent is 140 degrees F (60 degrees
C) and Type III Drycleaning Solvent is 200 degrees F (93 degrees C). Failure to do so may
result in injury or death to personnel.
If personnel become dizzy while using cleaning solvent, immediately get fresh air and
medical help. If solvent contacts skin or clothes, flush with cold water. If solvent contacts
eyes, immediately flush eyes with water and get immediate medical attention.
(1)
Check for worn, defective, or cracked areas on door assembly.
(2)
Clean excess adhesive and caulk from door assembly using dry cleaning solvent (Item 38, Appendix C).
d. Assembly.
(1)
Install screw stud snaps (26) on door
assembly (1) and FRS shelter (27) as
necessary.
Adhesives, solvents and sealing
compounds can burn easily, can
give off harmful vapors and are
harmful to skin and clothing. To
avoid injury or death, keep away
from open fire and use in
well-ventilated area. If adhesive,
solvent or sealing compound gets
on skin or clothes, wash
immediately with soap and water.
(2)
Install weather strip adhesive (25) and seal
(24) around door assembly (1).
(3)
Apply sealing compound to threads of ten
screws (22).
(4)
Install hinge (23) and ten screws (22) on
door assembly (1).
22
26
23
27
1
24
25
26
