TM 9-2330-389-14&P
Section II. SERVICE UPON RECEIPT
Paragraph Title
Paragraph No.
Page No.
General ........................................................................................................ 4-4 .......................................... 4-2
Inspection Instructions ................................................................................... 4-5 .......................................... 4-2
Servicing Instructions .................................................................................... 4-6 .......................................... 4-2
4-4.
GENERAL.
When a new, used, or reconditioned M200A1 Trailer with Tracked Suspension is received, determine whether it has been
properly prepared for service and is capable of performing its mission. Follow the inspection instructions in para 4-5 and
servicing instructions in para 4-6. For maintenance instructions on the MICLIC mounting brackets, notify Direct Support
Maintenance.
4-5.
INSPECTION INSTRUCTIONS.
a.
Refer to DD Form 1397 for procedures on unpacking the M200A1 Trailer with Tracked Suspension.
b.
Remove all straps, plywood, tape, seals, and wrappings.
WARNING
Dry cleaning solvent P-D-680 is toxic and flammable. Always wear protective
goggles and gloves, and use only in a well-ventilated area. Avoid contact with
skin, eyes, and clothes, and DO NOT breathe vapors. DO NOT use near open flame
or excessive heat. The solvent's flash point is 100° F-138°F (38° C-59°C). If you
become dizzy while using cleaning solvent, immediately get fresh air and medical
help. If solvent contacts eyes, immediately wash your eyes and get medical aid.
c.
Remove rust preventive compound from coated exterior parts of the M200A1 Trailer with Tracked Suspension
using dry cleaning solvent (Item 6, Appendix E) and rags (Item 5, Appendix E).
d.
Inspect trailer for damage incurred during shipment. Also check to see if the equipment has been modified.
e.
Check the equipment against the packing list to ensure that the shipment is complete. Report any
discrepancies in accordance with instructions in DA Pam 738-750.
4-6.
SERVICING INSTRUCTIONS.
a.
Perform all Operator/Crew and Unit PMCS. Schedule the next PMCS on DD Form 314.
b.
Lubricate all lubrication points as described in Chapter 3, Section I, regardless of interval.
c.
Report any problems on DA Form 2407.
d.
Perform a break-in road test of 5 mi. (8 km) at a maximum speed not to exceed 40 mph (70 kph).
4-2
