TM 9-2330-389-14&P
2-6.
GENERAL PMCS PROCEDURES.
WARNING
Dry cleaning solvent P-D-680 is toxic and flammable. Always wear protective
goggles and gloves, and use only in a well-ventilated area. Avoid contact with
skin, eyes, and clothes, and DO NOT breathe vapors. DO NOT use near open flame
or excessive heat. The solvent's flash point is 100°F-138F (38°C-59°C). If you
become dizzy while using cleaning solvent, immediately get fresh air and medical
help. If solvent contacts eyes, immediately wash your eyes and get medical aid.
a.
Keep equipment clean. Dirt, oil, and debris may cover up a serious problem. Clean as you work and as
needed. Use dry cleaning solvent (Item 6, Appendix E) on all metal surfaces. Use soap (Item 2, Appendix E)
and water on rubber, plastic, and painted surfaces.
b.
While performing specific PMCS procedures, inspect the following components:
(1)
Bolts, Nuts, and Screws. Ensure they are not loose, missing, bent, or broken. Report loose or missing
bolts, nuts, and screws to organizational maintenance.
(2)
Welds. Inspect for gaps where parts are welded together. Check for loose or chipped paint, rust, and
cracks. Report bad welds to unit maintenance.
(3)
Hoses, Lines, and Fittings. Inspect for wear, damage, and leaks. Ensure that clamps and fittings are
tight. Report any damage, leaks, or loose fittings to unit maintenance.
c.
Check that components are adequately lubricated in accordance with Chapter 3, Section I.
2-7.
SPECIFIC PMCS PROCEDURES.
a.
Operator/Crew PMCS is provided in Table 2-1. Always perform PMCS in the order listed. Once the PMCS
becomes routine, spotting problems will become much easier.
b.
Before performing PMCS, read all the checks required for the applicable interval and prepare all tools needed
for the task. Have several clean rags (Item 5, Appendix E) ready for use. Perform ALL inspections at the
applicable interval.
c.
If any problems are discovered through PMCS, perform the appropriate troubleshooting task as described in
Chapter 3, Section II. If any component or system is not serviceable, or if any service does not correct the
problem, notify your supervisor.
d.
The columns in Table 2-1 are defined as follows:
(1)
Item No. Provides a logical sequence for PMCS to be performed and is used as a source of item
numbers for the TM ITEM NO." column when recording PMCS results on DA Form 2404.
(2)
Interval. Specifies the interval at which the PMCS is to be performed.
(3)
Item To Be Inspected. Lists the system and common name of items that are to be inspected. Included
in this column are specific servicing, inspection, replacement, or adjustment procedures to be followed.
2-3