TM 9-2330-359-14&P
4-28. WIRING HARNESS REPAIR.
This Task Covers:
a.
Terminal Replacement
d .
Plug Assembly Repair
b.
Male Connector Repair
e.
Receptacle Repair
c.
Female Connector Repair
Initial Setup:
Equipment Conditions:
Materials/Parts:
Towing vehicle electrical connector disconnected
Contacts (as required)
from semitrailer (para 2-18).
Terminals (as required)
Tools/Test Equipment:
General mechanic’s tool kit
Common no. 2 shop set
1.
Cut terminal (3) off wire (1). Discard terminal.
2.
Strip insulation off wire (1) equal to depth of new
terminal (3).
3.
Slide insulator (2) on wire (1).
4.
Position new terminal (3) on wire (1). Crimp
terminal.
5.
Slide insulator (2) over crimped end of terminal
(3).
1.
Slide shell (5) back and remove washer (6) from
wire (4). Cut ferrule (7) from cable. Discard ferrule.
Remove shell.
2.
Strip insulation off wire (4) equal to depth of new
ferrule (7).
3.
Slide shell (5) on wire (4).
4.
Position new ferrule (7) on wire (4) and crimp.
5 .
Position washer (6) on wire (4) near crimping.
Slide shell (5) over washer and ferrule (7).
TA508011
4-34
