TM 9-2330-324-14&P
0033
00-4
SERVICE BRAKE ASSEMBLY MAINTENANCE—Continued
0033
00
ASSEMBLY
N O T E
If replacing brakeshoes (8 and 17) only, perform steps 4 through 9.
1.
Install pins (6, 18, 23, and 29) on brakeshoes (8 and 17) with four new lockwashers (9) and nuts
(10).
2.
Install slack adjusting wheel (27) and brake adjusting screw (28) on each support (12).
3.
Position backing plate (11), two supports (12), and cable ramp (25) on axle (13) and install 12 bolts
(26), new lockwashers (16), and nuts (15).
4.
Position brakeshoe (17) on backing plate (11) and install bolt (14), sleeve (22), flatwasher (21), new
lockwasher (19), and nut (20).
5.
Position brakeshoe (8) on backing plate (11) and install sleeve (33), flatwasher (32), new lockwasher
(31), and screw (30).
6.
Install link (7) on pin (23). Install brake lever (5) on pin (6). Pin on brake lever must engage slot in link.
7.
Install two spring washers (4), flatwashers (3), and slotted washers (2) on pins (6 and 23).
8.
Install two springs (1) on pins (6, 18, 23, and 29).
9.
Connect handbrake cable (24) to brake lever (5).
7
6
8
910
30
3132
33
29
1
28
27
26
25
12
12
11
13
14
15
16
24
2019
18
17
22
21
23
1
4
23
5
