TM 9-2330-238-14
2-18. USE OF 220-VOLT POWER CABLE (M313, M447, M447C, AND M750) (Con’t).
(4)
Unbuckle
strap (3) holding
end of power cable (4) to cable reel (1).
NOTE
On M313,
spring (Appendix C) must first be removed from end of power cable before it
can be unreeled.
(5)
Unreel and remove power cable (4) from reel barrel (6).
(6)
Connect one end of power cable (4) to connector
at power inlet housing at lower curbside
corner of
van body. Connect
other end of power cable to external power source.
b.
Reeling 220-volt
Power Cable.
(1)
Disconnect
power cable (4) from external power source and from connector at power inlet housing at
lower curbside
corner of van body.
(2)
Place end of power cable (4) in hole of reel barrel (6). Using handcrank
(9) or drive shaft wrench
(M313) rewind power cable onto cable reel (1). Secure free end of power cable to cable reel with strap (3).
(3)
Lock cable reel (1) by inserting cotter pin (7) through hole in reel shaft collar (8) and reel shaft (5).
NOTE
On M313,
power cable Is secured In stowed position with spring (Appendix
C).
(4)
Install nylon cover (2) to end of power cable (4), Chain of nylon cover should be wrapped
around
cable reel (1) to help secure power cable.
(5)
Install canvas cover on cable reel (1).
TA701931
2-31
