TM 9-2330-238-14
4-82. HOOK STRIP REPLACEMENT (Con't).
INSTALLATION
WARNING
b.
Dry cleaning solvent P-D-680 is toxic and flammable. Always wear protective goggles
or glasses and wear gloves. Use in a well ventilated area. Avoid contact with skin,
eyes, and clothes, and do not breath vapors. Do not use near open flames or excessive
heat. The solvents flash point Is 100oF-138°F (38°C-59°C). If you become dizzy while
using cleaning solvent immediately get fresh air and medical help. If solvent contacts
eyes, immediately flush your eyes and get medical aid. Failure to follow this warning
may result In injury or death to personnel.
NOTE
Make sure end-plate or corner post mounting surfaces are clean. Hook strips
are adhesive backed, and clean mounting surfaces are necessary for proper
bonding.
1.
Clean all mounting surfaces with dry cleaning solvent.
NOTE
Use existing rivet holes as a placement guide for installing new hook strip.
2.
Aline new 1-inch (2.54 cm,) hook strip (5) 1/16
(1.59mm) to 1/8-inch (3.17mm) down from from
top edge of lower door (4). Note position of rivet
holes before covering with hook strip (5).
4-200
Change 1
