TM 9-2330-238-14
Section Il. SERVICE UPON RECEIPT
Page
Paragraph Title
Number
General
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
4-2
Inspection
Instructions
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
. . . . . . . . . . . . . . . . . . . . . . . .
4-2
Servicing
Instructions
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
4-2
4-4.
GENERAL.
When anew, used,
or reconditioned
semitrailer,
van body, or chassis
isfirst received,
determine whether ithas
been properly
prepared
for service
and is
in condition
to perform its mission.
Follow the inspection
instructions in
paragraph
4-5 and servicing
instructions
in paragraph
4-6.
4-5.
INSPECTION
INSTRUCTIONS.
a.
Refer to DD Form 1397
for procedures
on unpacking
the semitrailer,
van body, or chassis.
b.
Remove all straps,
plywood,
tape, seals, and wrappings.
WARNING
Dry cleaning solvent, P-D-680,
is toxic and flammable.
Always wear protective goggles
and gloves, and use only in a well-ventilated
area. Avoid contact with skin, eyes, and
clothes, and DO NOT breathe vapors. DO NOT use near open flame or excessive heat.
The solvents
flash point Is 100°F-138°F
(38°C-59°C).
If you become
dizzy while
using cleaning solvent, immediately
get fresh air and medical help. If solvent contacts
eyes, immediately
wash your eyes and get medical aid.
c.
Remove rust preventive compound
from coated exterior parts of the semitrailer, van body, or chassis using
dry cleaning
solvent (Item 14, Appendix
E) and rags (Item 11, Appendix
E).
d.
Inspect the semitrailer, van body, or chassis for damage incurred during shipment.
Check also to see if the
equipment
has been modified.
e.
Check
the equipment
against
the packing
list to ensure
discrepancies
in accordance
with instructions
in DA Pam 738-750.
4-6.
SERVICING
INSTRUCTIONS.
that the shipment
is complete.
Report any
a.
Perform all Operator/Crew
and Organizational
PMCS. Schedule
the next PMCS on DD Form 314.
b.
Lubricate
all lubrication
points as described
in Chapter 3, Section I, regardless
of interval.
c.
Report any problems
on DA Form 2404.
d.
Perform a break-in
road test of 25 miles (40 km) at a maximum
speed of 50 mi/h (80 km/h).
4-2
