TM 55-8115-203-23 & P
Overall Length
+0 inch /- 1/4 inch
Overall Width
+0 inch /- 3/]6 inch
d. Diagonal Distance Between Opposite Corner Fittings. Check alignment of the container by comparing the
diagonal measurements between corner fittings on opposite corners of the container. Allowable differences
between the two opposite corner measurements on a single side are listed below. An explanatory diagram and
exact measuring procedures are included in figure 3-1.
Ends
+0 - 3/8 inch
Top, bottom, sides
+0 - 3/8 inch
Section III. REPAIR PARTS, SPECIAL TOOLS AND EQUIPMENT
1-10. Special Tools and Equipment. No special tools or equipment are required.
1-11. Repair Parts. Repair parts are listed and illustrated in Appendix C of this manual.
1-12. Fabricated Tools and Equipment. No fabricated tools or equipment are required.
1-7/(1-8 blank)
