TM 5-4930-244-14
6-5. CAMSHAFT-REPLACE.
This Task Covers:
a.
Removal
b.
Installation
Initial Setup:
Tools and Test Equipment Required
Tool Kit, General Mechanic's: Automotive (Appendix B, Section II, Item 1).
Adapter, 1/2 inch Drive (Appendix B, Section III, Item 17).
Arbor Press (Appendix B, Section III, Item 13).
Puller Kit (Appendix B, Section III, Item 22).
Chemical and Oil Protective Gloves (Appendix B, Section III, Item 8).
Dial Indicator (Appendix B, Section III, Item 23).
Gearwheel Puller (Appendix B, Section III, Item 19).
Industrial Goggles (Appendix B, Section III, Item 9).
Torque Wrench, 0-175 ft-lbs (Appendix B, Section III, Item 21).
Materials/Parts Required
Dry Cleaning Solvent (Appendix E, Section II, Item 3).
Sealing Compound (Appendix E, Section II, Item 5).
Gasket (Appendix H, Section II, Item 60).
Packing, Preformed (Appendix H, Section II, Item 61).
Seal, Oil (Appendix H, Section II, Item 62).
Wiping Rags (Appendix E, Section II, Item 1).
Woodruff Key (Appendix H, Section II, Item 59).
Equipment Condition
Cylinder Head Removed (para. 6-2).
Oil Pan and Gasket Removed (para. 5-10j ).
Fuel Injection Pump Removed (para. 5-10.d.).
Fuel Lift Pump Removed (para. 5-10.f.).
a. Removal. (Refer to Figure 6-4).
CAUTION
Gear cover (1) is mounted on dowels (2) secured to crankcase (3). Care should be
taken when removing cover (1) to prevent damage to dowels (2).
(1)
Remove fuel life pump push rod (4) from crankcase (3).
NOTE
Do steps 2 and 3 to remove access cover (5) as required.
(2)
Remove screw (6), from crankcase (3).
(3)
Remove seven screws (7), cover (1), and gasket (8) from crankcase (3).
6-25