TM 5-4930-244-14
WARNING
Handling hot items presents a serious burn potential. Temperature resistant
gloves are required.
NOTE
Insufficient heat or delay In installing gear (12) could cause the gear to become
jammed on the crankshaft (20), whereas overheating may cause softening of the
gear (12).
(15)
Heat the crankshaft gear (12) to straw yellow and install it on the crankshaft (20) without delay.
(16)
Install plate (15), without the packing (16), and install screw (14). Torque to 27.5 Ib-ft (37.5 Nm).
(17)
When the gear (12) has cooled sufficiently, remove the plate (15).
(18)
Soak new packing (16) in engine oil at ambient temperature for 24 hours. Install new packing (16) on plate (15)
and install plate by pushing it into position. Resistance will be felt due to the new packing (16).
(19)
Install screw (14) and torque to 27 5 Ib-ft (37.5 Nm).
NOTE
Do step 17 only if access cover (9) was removed.
(20)
Install new packing (10). Apply sealing compound to two screws (7). Install screws (7), washers (8) and cover
(9) on cover (1).
(21)
Install new seal (11) in gear cover (1).
(22)
Install new gasket (6) on crankcase (3).
(23)
Apply sealing compound on seven screws (5) and long screw (4).
(24)
Install cover (1) and screws (4 and 5) to crankcase (3).
(25)
Torque screws (4 and 5) to 9 Ib-ft (12 Nm).
(26)
Install fuel Injection pump (Reference para. 5-10 d.).
(27)
Install fuel lift pump (Reference para. 5-10.f.).
(28)
Install cylinder, piston, and connecting rod assembly (Reference para. 6-3).
(29)
Perform engine running-in (Reference para. 6-10).
6-22
