TM 5-4930-244-14
(17)
Install cylinder head (Reference para. 5-10.k.)
(18)
Turn engine to TDC.
(19)
Remove cylinder head (Reference para. 5-10 k.).
(20)
Remove solder (26) and measure thickness with micrometer.
(21)
Check that thickness of solder (26) is 0.022 inch to 0.030 inch (0 56 mm to 0.76 mm) for average of three
readings (one reading for each piece of solder (26))
(22)
If bumping clearance is not within tolerance, do steps 23 and 24. If bumping clearance is within tolerances, do
steps 25 thru 27.
(23)
Add or remove shims under cylinder (Reference para 6-2.a 3 ).
(24)
Repeat steps 16 thru 22. If bumping clearance is correct, do steps 25 thru 27. If bumping clearance is incorrect,
go back to step 23.
(25)
Install oil pan and gasket (Reference para. 5-10.k.)
(26)
Install cylinder head (Reference para 5-10 k ).
(27)
Perform engine running-in (Reference para. 6-10).
6-13
