TM 5-4930-244-14
(3)
Slide paper element (22) from screen (21). If dirty, discard old paper element (22).
(4)
Install new paper element (22) into screen (21).
(5)
Install upper cap (18), circular screen (19) and base (20) onto screen (21).
(6)
Install two threaded bolts (17) through upper cap (18), paper element (22) and base (20). Secure using two new
locknuts (16).
c. Installation.
NOTE
·
The following procedures will be the same for all pumps except as noted.
·
Before installation, wrap muffler and elbows threads with Teflon Tape.
(1)
Apply silicon sealant around pump openings.
(2)
Insert pumps (3) into lube tank (12).
(3)
For high pressure pump only, install baffle (15) onto high pressure pump (3) tube, 7 1/2 inches from the bottom of
the tube. Tighten two set screws (14) on baffle (15).
(4)
Install four hex head - cap screws (10), four washers (11) through pressure pumps (3) into lube tank (13). Install
four flanged locknuts (12) onto the four hex head - cap screws (10) inside lube tank (13). Tighten.
(5)
Install hoses assemblies (6) with attached needle valves (7) into street elbows (8), and lube tank (13).
(6)
Install elbow swivel adapters (5) into pumps (3). Reconnect hose assemblies (4) to elbows swivel adapters (5).
(7)
Install elbows (2) into pressure pumps (3). Screw pump mufflers (1) into elbows (2). Hand tighten.
4-134
