TM 5-4930-244-14
CHAPTER 2
OPERATING INSTRUCTIONS
Paragraph
Page
Section I.
Description and Use of Operator Controls and Indicators...................................................2-1
2-1.
Introduction ..........................................................................................................................2-1
2-2.
Operator Controls and Indicators ...........................................................................................2-1
Section II.
Operator Preventive Maintenance Checks and Services (PMCS) ........................................2-10
2-3.
General ................................................................................................................................2-10
2-4.
PMCS Procedures ................................................................................................................2-10
2-5.
Leakage Definitions for Operator PMCS .................................................................................2-11
2-6.
Operator Preventive Maintenance Checks and Services ..........................................................2-12
Section III.
Operation Under Usual Conditions .....................................................................................2-26
2-7.
Assembly and Preparation for Use .........................................................................................2-26
2-8.
Initial Adjustments and Checks ..............................................................................................2-28
2-9.
Operating Procedures ...........................................................................................................2-28
2-10.
Decals and Instruction Plates .................................................................................................2-43
2-11.
Shutdown Procedures ...........................................................................................................2-53
Section IV.
Operation Under Unusual Conditions .................................................................................2-56
2-12.
Operation in Unusual Environment/Weather ...........................................................................2-56
2-13.
Emergency Procedures .........................................................................................................2-61
2-14.
Nuclear, Biological, and Chemical (NBC) Decontamination Procedures .....................................2-63
Section I. DESCRIPTION AND USE OF OPERATOR CONTROLS AND INDICATORS
2-1.
INTRODUCTION.
This section provides the operator with information needed to locate, identify, and use the controls and indicators on the
Lube Unit. The components and controls identified in this section are applicable to the entire system. Some of the
controls are repeated throughout the system.
2-2.
OPERATOR CONTROLS AND INDICATORS.
a.
Door Latches. (Refer to figure 2-1).
Located on the enclosure (1), these latches (2) are used to open and close front, rear and side doors.
Figure 2-1. Flush-Mounted Door Latches
2-1
