TM 5-3825-230-14&P
Section II. OPERATOR PREVENTIVE MAINTENANCE CHECKS AND SERVICES (PMCS)
2-3. PMCS INTRODUCTION.
a.
PMCS Procedures. To ensure that the sweeper is ready for operation at all times, it must be inspected
systematically so that defects may be discovered and corrected before they result in serious damage or failure. Table 2-1
contains a tabulated listing of preventive maintenance checks and services to be performed by the operator.
(1)
Do the before (B) preventive maintenance just before operating the sweeper. Pay attention to the
CAUTIONS and WARNINGS.
(2)
Do the during (D) preventive maintenance while the sweeper is in operation. Pay attention to the
CAUTIONS and WARNINGS.
(3)
Do the after (A) preventive maintenance right after operating the sweeper.
(4)
Do the (W) preventive maintenance on a weekly basis.
(5)
Do the (M) preventive maintenance on a monthly basis.
(6)
If something does not work properly, troubleshoot using the instructions in Chapter 3. Report any
deficiencies using the proper forms.
(7)
Always do preventive maintenance in the same order until it gets to be a habit. Once practiced, problems
can be spotted in a hurry.
(8)
When doing preventive maintenance, take along the tools needed and a rag or two to make all the checks.
(9)
Report all deficiencies on DA Form 2404.
b.
Equipment is not ready/available if: procedures. The terms ready/available and mission capable refer to the
same status: equipment is on hand and is able to perform its combat mission (see AR 700-138).
2-4. SPECIAL INSTRUCTIONS.
a.
Shortened Maintenance Instructions. Local conditions of extreme heat, dust, cold, or wetness dictate that
service intervals may need to be shortened.
b.
Additional Maintenance Inspections. Additional maintenance inspections may be required for the following
reasons:
(1)
Prolonged storage. Vehicles having been stored for a period of three months or more should be inspected.
(2)
Initial preparation upon receipt.
(3)
Preparation for storage.
c.
Fluid Leakage. It is necessary to know that fluid leakage affects the status of fuel, oil, coolant, and the hydraulic
systems. The following are definitions of the different types/classes of leakage that determine the status of the sweeper.
2-7
