TM 5-3825-230-14&P
4-100. DECAL REPLACEMENT.
This task covers:
a.
Removal
b.
Cleaning/Inspection
c.
Installation
INITIAL SETUP
Tools
Materials/Parts
Tool Kit, General Mechanic's: Automotive
Decal
Solvent, dry cleaning, item 31, Appendix E
a.
Removal Peal damaged decal from vehicle
using a putty knife.
WARNING
Dry cleaning solvent P-D-680 is toxic and
flammable. Wear protective goggles, face
mask, and gloves and use only in a well
ventilated area. Avoid contact with skin,
eyes, and clothes and don't breathe vapor.
Do not use near open flame or excessive
heat. The flashpoint for type I dry cleaning
solvent is 100°F (38°C) and for type II is
140°F (60°C). If you become dizzy while
using
cleaning
solvent,
get
fresh
air
immediately and get medical aid. If contact
with eyes is made, flush eyes with water and
get medical aid immediately.
b.
Cleaning/Inspection. Using dry cleaning solvent P-D-680, thoroughly clean area where decal will be installed.
NOTE
Surface should be clean and dry before applying new decal.
c.
Installation. Remove paper backing and install new decal.
END OF TASK
4-178
