TM 5-3825-230-14&P
4-84. HAND BRAKE LEVER REPLACEMENT (CONT).
(3)
Remove four screws (6), four lockwashers (7),
and four nuts (8) using a.1/2 in. open end
wrench, ratchet and 1/2 in. socket.
(4)
Remove screw (9), locknut (10), and socket
shaft linkage (11) using a 7/16 in. open end
wrench, ratchet and 7/16 in. socket.
(5)
Remove hand brake assembly (12).
(6)
Remove cotter pin (13), washer (14), two bars
(16), and pin (15) using needle nose pliers.
b. Installation.
(1)
Install washer (14), two bars (16), pin (15), and
cotter pin (13) using needle nose pliers.
(2)
Install hand brake assembly (12), four screws
(6), washers (7), and locknuts (8) using a 1/2 in.
open end wrench, ratchet and 1/2 in. socket.
(3)
Install screw (9), locknut (10), and socket shaft
linkage (11) on hand brake assembly (12) using
a 7/16 in. open end wrench, ratchet and 7/16 in.
socket.
(4)
With end of shaft linkage in bushing, install bushing (5) on bracket (4) using four screws (1), four lockwashers (3),
and four nuts (1). Tighten using a 7/16 in. open end wrench, ratchet and 7/16 in. socket.
NOTE
Follow-on maintenance: Adjust hand brake (para 3-12)
END OF TASK
4-140
