TM 5-3820-245-14&P
CHAPTER VI,
REPAIR INSTRUCTIONS
INTRODUCTION
The instructions contained in this section are intended for use by personnel responsible for servicing and repairing
the Model 270-9 Auger.
6-1
HYDRAULIC SYSTEM NOTE
Before starting any hydraulic type repair, the hydraulic reservoir must be plugged. To do this, the following steps
must be observed:
A. The hydraulic reservoir top plate must be removed. See Reservoir Illustration, Figure 6-1.
B. Push down on suction release adapter (Item 1), then pull up to release.
C. Place auxiliary plug (Item 2) in suction release adapter (Item 1) position before removal.
This will stop the flow of hydraulic oil thru the hydraulic system while working on hydraulic repairs.
CAUTION
REMEMBER TO REPLACE SUCTION RELEASE ADAPTER
PLUG AFTER ALL REPAIRS HAVE BEEN COMPLETED.
FIGURE 6-1. HYDRAULIC RESERVOIR
1. ADAPTER
2. PLUG-AUXILIARY
PAGE 59
