TM 5-3805-296-23-4
0290
INSTALLATION CONTINUED
WARNING
Use caution when using brake cleaner. Prolonged inhalation of vapors can cause lung
irritation. Contact with skin can cause dermatitis. Wear gloves and safety goggles and use
product in a well-ventilated area away from open flame. If ingested, keep individual calm
and seek medical attention. DO NOT induce vomiting. If contact with skin or eyes is made,
flush thoroughly with water. Dispose of cleanup rags IAW local policy and ordinances.
Failure to follow this warning may result in injury to personnel.
3. Clean seal (Figure 5, Item 3) with brake cleaner.
4. Loosen nut (Figure 5, Item 4) on seal installer (Figure 5, Item 2).
NOTE
Seal will sit in groove on installer.
5. Insert seal (Figure 5, Item 3) on seal installer (Figure 5, Item 2).
6. Tighten nut (Figure 5, Item 4) on seal installer (Figure 5, Item 2).
7. Using seal installer (Figure 5, Item 2), install seal (Figure 5, Item 3) in tire and wheel assembly
(Figure 5, Item 1).
8. Loosen nut (Figure 5, Item 4) and remove seal installer (Figure 5, Item 2) from seal (Figure 5, Item 3).
Figure 5. Wheel Seal.
0290