TM 5-3805-296-23-2
0151
Table 1. One or Both Stop Lights Do Not Operate, Turn Signals Operate Normally Continued.
0151
MALFUNCTION
TEST OR INSPECTION
CORRECTIVE ACTION
2. Using digital multimeter
One or Both Stop Lights Do
Resistance 5.0 Ohms or Less
(WP 0540), measure resistance
Not Operate, Turn Signals
Proceed to step 3.
between H-C9 terminal K
Operate Normally
Resistance Greater Than 5.0 Ohms
(WP 0012, Figure 242) and
Continued
Replace headliner wire harness
connector H-C7 terminal 31
(WP 0497).
(WP 0012, Figure 225).
Proceed to Test Step 12.
3. Using digital multimeter
Resistance 5.0 Ohms or Less
(WP 0540), measure resistance
Proceed to Test Step 6.
between H-C9 terminal C
Resistance Greater Than 5.0 Ohms
(WP 0012, Figure 242) and
Replace headliner wire harness
connector H-C7 terminal 27
(WP 0497).
(WP 0012, Figure 225).
Proceed to Test Step 12.
Test Step 6. Test Military Light
Switch for High Resistance or Open.
1. Turn mode switch on military light
switch to SER. DRIVE position
(TM 5-3805-296-10).
2. Using digital multimeter
Resistance 5.0 Ohms or Less
(WP 0540), measure resistance
Proceed to step 3.
between military light switch
Resistance Greater Than 5.0 Ohms
terminal C and terminal K
Replace military light switch (WP 0517).
(WP 0012, Figure 241).
Proceed to Test Step 12.
3. Turn mode switch on military light
switch to STOP LIGHT position
(TM 5-3805-296-10).
4. Using digital multimeter
Resistance 5.0 Ohms or Less Turn
(WP 0540), measure resistance
mode switch on military light switch to
between military light switch
OFF position (TM 5-3805-296-10).
terminal C and terminal K
Proceed to Test Step 7.
(WP 0012, Figure 241).
Resistance Greater Than 5.0 Ohms
Replace military light switch (WP 0517).
Proceed to Test Step 12.
Test Step 7. Test Main Cab Wiring
Harness for High Resistance or
Open.
1. Remove upper and lower plenum
from ROPS (WP 0504).
2. Disconnect connector W-C7
(WP 0012, Figure 252)
from connector P-C1
(WP 0012, Figure 253).
0151-5