TM 5-3805-296-23-2
0136
Table 1. One or Both Blackout Tail Lights Do Not Operate Continued.
0136
MALFUNCTION
TEST OR INSPECTION
CORRECTIVE ACTION
3. Using digital multimeter
One or Both Blackout Tail
Continuity Replace draft frame and
(WP 0540), test for continuity
Lights Do Not Operate
bowl side wiring harness (WP 0348).
between connector AE-C4
Continued
Proceed to Test Step 20.
terminal 11 (WP 0012, Figure 174)
No Continuity Proceed to step 4.
and all other terminals in
connector AE-C4
(WP 0012, Figure 174).
4. Using digital multimeter
Continuity Replace draft frame and
(WP 0540), test for continuity
bowl side wiring harness (WP 0348).
between connector AE-C4
Proceed to Test Step 20.
terminal 11 (WP 0012, Figure 174)
No Continuity Proceed to step 5.
and ground.
5. Using digital multimeter
Continuity Replace draft frame and
(WP 0540), test for continuity
bowl side wiring harness (WP 0348).
between connector AE-C1
Proceed to Test Step 20.
terminal 35 (WP 0012, Figure 144)
No Continuity Proceed to Test
and all other terminals in
Step 9.
connector AE-C1
(WP 0012, Figure 144).
Test Step 9. Test Draft Frame and
Bowl Side Wiring Harness for High
Resistance or Open.
1. Connect jumper wire between
connector AE-C4 terminal 6 and
terminal 11 (WP 0012, Figure 174).
2. Using digital multimeter
Resistance 5.0 Ohms or Less
(WP 0540), measure resistance
Proceed to Test Step 10.
between connector AE-C1
Resistance Greater Than 5.0 Ohms
terminal 31 and terminal 35
Replace draft frame and bowl side
(WP 0012, Figure 144).
wiring harness (WP 0348).
Proceed to Test Step 20.
0136-9