TM 5-3805-296-23-2
0067
Table 1. 0708 Transmission Downshift Solenoid Valve Diagnostic Codes Continued.
067
CID FMI
TEST OR INSPECTION
CORRECTIVE ACTION
3. Connect jumper wire between
0708-05 Transmission Gear
terminal 1 and terminal 2
Actuator Down Solenoid
of connector A-C8
Current Below Normal
(WP 0012, Figure 112).
Continued
4. Turn battery disconnect switch and
ignition switch to ON position
(TM 5-3805-296-10).
5. At MSD, check for active
708-6 Transmission Gear Actuator
diagnostic code 708-5
Down Solenoid Current Above
Transmission Gear Actuator Down
Normal Becomes Active Replace
Solenoid Current Below Normal
downshift solenoid (WP 0274).
(WP 0008).
Proceed to Test Step 5.
708-5 Transmission Gear Actuator
Down Solenoid Current Below
Normal Remains Active Proceed to
Test Step 2.
Test Step 2. Test Transmission
Wiring Harness for High Resistance
or Open.
1. Turn ignition switch and battery
disconnect switch to OFF position
(TM 5-3805-296-10).
2. Do not remove jumper wire from
terminal 1 and terminal 2
of connector A-C8
(WP 0012, Figure 112).
3. Disconnect connector A-C1
(WP 0012, Figure 106)
from connector J-C3
(WP 0012, Figure 101).
4. Using digital multimeter
Resistance 5.0 Ohms or Less
(WP 0540), measure resistance
Proceed to Test Step 3.
between connector AC-C1
Resistance Greater Than 5.0 Ohms
terminal 4 and terminal 15
Replace transmission wiring harness
(WP 0012, Figure 106).
(WP 0266).
Proceed to Test Step 5.
Test Step 3. Test Chassis Wiring
Harness for High Resistance or
Open.
1. Remove jumper wire from
terminal 1 and terminal 2
of connector A-C8
(WP 0012, Figure 112).
2. Connect jumper wire between
terminal 4 and terminal 15
of connector J-C3
(WP 0012, Figure 101).
0067-5