TM 5-3805-296-23-1
0061
Table 1. 0590 Communication Diagnostic Codes Continued.
061
CID FMI
TEST OR INSPECTION
CORRECTIVE ACTION
Test Step 1. Test Voltage of Battery
0590-02 Engine Control
Supply Circuits at Engine ECM.
Module Incorrect Signal
1. Turn ignition switch and battery
Continued
disconnect switch to OFF position
(TM 5-3805-296-10).
2. Lower left frame access plate
(WP 0376).
3. Remove four bolts
(Figure 1, Item 1), washers
(Figure 1, Item 2), bushings
(Figure 1, Item 3), and splash
shield (Figure 1, Item 4) from
machine.
Figure 1. Splash Shield and Retaining Hardware.
0061
4. Disconnect connector CL-C1
(WP 0012, Figure 45) from engine
ECM.
5. Turn battery disconnect switch and
ignition switch to ON position
(TM 5-3805-296-10).
6. Using digital multimeter
Voltage 18 to 25 V Proceed to step 7.
(WP 0540), test for voltage
Voltage Less Than 18 V Proceed to
between CL-C1 terminal 48
Test Step 3.
(WP 0012, Figure 45) and ground.
7. Using digital multimeter
Voltage 18 to 25 V Proceed to step 8.
(WP 0540), test for voltage
Voltage Less Than 18 V Proceed to
between CL-C1 terminal 52
Test Step 3.
(WP 0012, Figure 45) and ground.